In order to use this microphone, you will need an audio interface or an audio mixer that can supply +48v of phantom power to your AT2020 Microphone. This means that XLR to USB Cables or XLR to 1/8″ Cables will not work with this microphone because they do not provide the +48v that is required. The AT2020 is not an exception to this rule. All condenser microphones require +48v of Phantom power in order to activate the microphone. The Audio Technica AT2020 is a condenser microphone. This includes products or services from Amazon, Sweetwater, B&H Photo, Best Buy, Guitar Center, and more.įor more information, read our ethics and disclosure page.In this article we discuss the 5 most common mistakes that we see people make with the Audio Technica AT2020 Condenser Microphone. 3:10 – Connect AT2020 To Elgato Wave XLRĭisclosure: If you purchase an item or service from an outbound link, we may receive a referral fee from a qualifying purchase.Audio Technica AT2020 Condenser Microphone: Įlgato Wave XLR & Audio Technica AT2020 | Setup & Demo Topics.Elgato Wave XLR & Audio Technica AT2020 Pricing & Specs It sounds terrible live, and you can’t recover clipped audio in a recording. If the level hits 0 dB, your mic will clip and sound distorted. We aim to keep the level under -12 dB as this gives you room to get louder, perhaps while animated or laughing.
Setting the gain to 30% worked best for our setup. Then turn the dial while speaking naturally into the AT2020 until you find the correct level. Single press the large button on the Elgato XLR interface until the light under the microphone symbol illuminates. You’re aiming to find a gain setting that allows your audio signal to peak somewhere in the range of -18 dB and -12dB on the meter in your audio software. Gain boosts the level of the audio signal from your microphone. Elgato Wave XLR & Audio Technica AT2020 Gain Settings To activate phantom power, press and hold the large rotary button until this light comes on. In the bottom right corner of the Elgato Wave XLR’s interface, you’ll see a small “48V” symbol with the light turned off. It’s not that they sound bad without it they literally won’t work at all. The Audio Technica AT2020 is a condenser microphone, all of which require 48 V of phantom power to activate them. Elgato Wave XLR & Audio Technica AT2020 Phantom Power If you see this, press the mute button again to unmute your AT2020. If you have pressed the button and muted the mic, all of the lights around the interface’s large rotary button will turn red. It’s a touch-activated button that gives no physical feedback or indication when pressed, so it’s easy to mute the AT2020 without realizing it.
Look on the top of the Elgato Wave XLR, and you’ll see a mute button. Use a pop filter of foam windscreen this is one of the most common AT2020 mistakes we see people making. The AT2020’s logo should be facing your mouth. This is a side-address microphone, meaning you talk into the side and not the top. Position the mic around a fist’s width from your mouth Here are some tips to make sure you have the AT2020 positioned correctly: One of the most important aspects of getting the best sound from your AT2020 and Elgato XLR setup should happen before you even connect them mic placement.
0 kommentar(er)
